XTREME PRO HIGH TACK WHITE (1PC)

Suitable for indoor and outdoor applications, such as panels, ceiling elements, booids, drywall, plate and insulation materials, mirrors, control, baseboards and scraps.

For all professional applications, such as facade and interior construction, home, utility and bodybuilding. Not suitable for PE, PP, PTFE, pure plaster, and bitumen. Always perform a suture test when bonding plastic. The adhesion to plastic can vary &; run depending on the type of plastic and the quality of the plastic.

Properties;

· very high starting attachment

Very fast strength building

· permanent elastic

Very good filling power

· good standing power

· shrink free; 100% glue

· solvent free

· no edge zone pollution

· weather resistant

· temperature resistant from -40 ° C to + 100 ° C

· Paintable

· cutting approx. 2 mm / 24 hours

Preparation;

Processing conditions: The temperature of environment, the glue and the materials to be glued may not be lower than + 5 ° C.

Pre-treatment surfaces: parts must be clean, dust and grease-free. Ensure a sturdy surface. Substrate may be light-moist.

Primer use no need.

Consumption: from 1 sleeve comes around 7-9 meters glue.

Instructions for use:

Process only with special supplied nozzle. Cut thread and mount nozzle. Glue evenly, depending on the gravity of the material, to apply the 10 to 40 cm in vertical stripes or dots. Always apply glue to corner points and along edges. Material action (façade panels) can be collected by glue thickness of 3 mm (use distance cubes or tape). Mounting materials directly with a sliding motion and press firmly or beat. Correcting is still possible. Immediately close sleeve after use.

Stains / Remains:

Wet glue residues immediately remove with turpentine. Dried glue residues can only be removed mechanically.

Points of attention:

Drying times below are based on the bonding of minimum & EACUTE; & EACUTE; N porous material and a glue layer with a thickness of approx. 1 mm. In the bonding of two non-porous materials and / or a thicker adhesive layer, considerably longer drying times must be taken into account.

Dry times;

Skin forming time: approx. 10-15 minutes

Hand-retaining time: approx. 30 minutes. This can be Vari & Euml; run depending on the circumstances, such as temperature and humidity.

Cover speed: approx. 2 mm / 24 hours

Dry / curing time: approx. 4 hours. This can be Vari & Euml; run depending on the circumstances, such as temperature and humidity.